Precautions for operation of FTTH drop cable production line

1. FTTH drop cable production line computer communications plug please do not plug at will, not plug or plug in the wrong sequence may cause the incorrect operation of the monitoring software;

2. Before the computer runs the monitoring software, please ensure that the PLC is in the running state, do not start after the monitoring software runs;

3. At any time to ensure that the wire diameter detector lens of FTTH drop cable equipment is clean, do not splash on the lens, otherwise it is easy to cause the phenomenon of inaccurate measurement;

4 .do not delete the software in the computer or change the Settings of the computer, otherwise it is easy to cause the incorrect operation of the monitoring software; Shut down the computer, please follow the normal computer operation steps, do not exit the operating system and directly shut down the power;

5. During the operation of FTTH drop cable equipment, if there is a large deviation between the pre-set production parameters and the actual production, please ask professional personnel to reset, do not set by yourself;

6 .Under normal production conditions of the drop cable production line , use the mouse to click on the button after the operation, such as screw because the computer after the communication with PLC, PLC produced after the start or stop the action of extruder, only after the click action of the PLC will produce, according to the results back to the computer for monitoring software on this after two computer and PLC communication, The button state changes with a slight lag, which is normal; If the button state is not changed for a long time, please check whether the communication between the computer and PLC is normal;

7. When you click to enter data, note the input range as prompted to avoid incorrect input.